 |
|
Board index » FlyTampa » Vienna - LOWW
Page 1 of 1
problems with vienna und fs9
by chris1801 » Thu Mar 30, 2006 9:59 am
always when I try to start fs9, I only see the start frame, not more ... and this, since I have installed vienna from flytampa ... does anyone know where the problem could be?
- chris1801
- Posts: 3
- Joined: Thu Mar 30, 2006 9:57 am
by martin[flytampa] » Fri Mar 31, 2006 4:49 am
You mean it crashes immidatly before you even get to select "loww" not allowing you to use FS at all anymore?
- martin[flytampa]
- Site Admin
- Posts: 3702
- Joined: Wed Oct 01, 2003 8:12 am
- Location: Tampa/FL
by martin[flytampa] » Sat Apr 01, 2006 1:12 am
two things you should try, each after backing up the respective files first.
1. Backup and delete C:\Documents and Settings\Username\Application Data\Microsoft\FS9\fs9.cfg
and load again.
2. Open FS9/scenery.cfg in notepad, scroll to the very bottom/end of the file and see if the latest entry looks correct. It should be similar to this, ?? are numbers:
[Area.??]
Title=FlyTampa-Vienna
Local=C:\somefolder\FlyTampa-Vienna
Remote=
Active=TRUE
Required=FALSE
Layer=??
If it doesn't look similar but messed up, you should delete this set of lines , save and see if FS runs. If it does add Vienna by hand as described on the support page.
1. Backup and delete C:\Documents and Settings\Username\Application Data\Microsoft\FS9\fs9.cfg
and load again.
2. Open FS9/scenery.cfg in notepad, scroll to the very bottom/end of the file and see if the latest entry looks correct. It should be similar to this, ?? are numbers:
[Area.??]
Title=FlyTampa-Vienna
Local=C:\somefolder\FlyTampa-Vienna
Remote=
Active=TRUE
Required=FALSE
Layer=??
If it doesn't look similar but messed up, you should delete this set of lines , save and see if FS runs. If it does add Vienna by hand as described on the support page.
- martin[flytampa]
- Site Admin
- Posts: 3702
- Joined: Wed Oct 01, 2003 8:12 am
- Location: Tampa/FL