Board index » FlyTampa » Boston-Logan - KBOS

[miata54]

My WoAI AC are touching down about a 1/4 mile south of the runway (4L) which puts them in Boston Harbor. The only AFCAD file I have for FT KBOS is the file that came with the program. There are no other AFCAD's for KBOS anywhere on my system. I have patches 3.1 & 3.2 installed. Can I adjust the glide slope to correct this and if so, just where would I put the NAVAID?

Thanks

[george[flytampa]]

Thais normal for the first few minutes until the AI settles down. I recall it happening in FS8, FS9 & FSX. I think its just Microsoft coding magic & it can effect all busy airports.

If it happens for longer, you might have another problem I can't think of right now.

PS. You sure you mean 4L? That runway is closed for landings in our AFCAD. Maybe double check you don't have duplicate(afcad) still running because 4L & 22R shouldn't have anything landing on it.

[miata54]

Yeah, it could have been, probably was, 4R, as I was viewing it at night from an angle! Got a bunch of wet passengers.

Thanks