Board index » FlyTampa » FlyTampa-Toronto

Post
 tommaGT (Thu Jan 11, 2018 10:39 pm)

Posts: 2
Hi

I just purchased Toronto for P3Dv4 and it is excellent!

However, I am experiencing a strange issue where if I fly any default aircraft over a specific part of the airport at around 1-2000 ft, the aircraft crashes in mid-air. It is not a CTD, but an aircraft crash, afterwhich the sim reloads the default scenario. I have attached a screenshot of approximately where this happens every time. I have tried a number of aircraft, including the Robinson 22 with the same result. I tried uninstalling FlyTampa Toronto and tested with the default Toronto airport and could not reproduce the crash. After reinstalling the FlyTampa airport, I could once again reproduce the crashes.

I do have 'Detect Crashes and Damage' checked, but do not have 'Vehicle Stress Causes Damage' or 'Allow Collision with Other Vehicles' checked.

I have tried searching for information about this, but without success. Any assistance would be much appreciated.

Thanks

Tom

FlyTampa Toronto Mid-Air Crash Issue.JPG
Screenshot showing roughly where mid-air crash occurs
FlyTampa Toronto Mid-Air Crash Issue.JPG (249.81 KiB) Viewed 529 times
Post
 martin[flytampa] (Sat Jan 13, 2018 10:28 am)

Site Admin | Posts: 5201 | Location: Tampa/FL
Replace the attached BGL in /FlyTampa/Toronto/scenery/. See if that fixes it.
CYYZ_TERRAIN_PLAT.BGL
(127.04 KiB) Downloaded 96 times
Post
 tommaGT (Sat Jan 13, 2018 10:21 pm)

Posts: 2
Thank you Martin! That fixed it. Very much appreciate your help and quick response. :D

Tom