KLAS runway selection in P3D

Post Reply
martyjr
Posts: 32

KLAS runway selection in P3D

Post by martyjr » Sun Feb 02, 2020 7:00 am

KLAS P3Dv4

When I start P3D KLAS , select runway, there are only:
1R , 19L
8L , 26R
Is that correct?

Note:
KLAS also has 8R , 26L , 1L and 19R but are not in the P3D runway selection list?
klas-rwys-p3d.JPG
klas-rwys-p3d.JPG (91.33 KiB) Viewed 468 times
emilios[flytampa]
Site Admin
Posts: 1218

Re: KLAS runway selection in P3D

Post by emilios[flytampa] » Sun Feb 02, 2020 8:25 am

Runway availability depends on the airport setup on the FlyTampa configuration tool-probably check there (in the comments box) for more details.
martyjr
Posts: 32

Re: KLAS runway selection in P3D

Post by martyjr » Sun Feb 02, 2020 9:20 am

Why is that?
Not able to select a KLAS departure from rwy 8R, 26L, 1L or 19R?

Note:
Aircraft (like PMDG) has all runways available for takeoff.
And SIDs use all runways for departures.
emilios[flytampa]
Site Admin
Posts: 1218

Re: KLAS runway selection in P3D

Post by emilios[flytampa] » Sun Feb 02, 2020 5:22 pm

This is to reflect (as much as possible) the real world traffic patterns, which depend on wind direction.
martyjr
Posts: 32

Re: KLAS runway selection in P3D

Post by martyjr » Mon Feb 03, 2020 2:26 am

Thanks for the reply.

I have never needed that feature on any payware airport scenery (fs9, fsx, xplane, p3d).

It would be great to have a legacy (default) configuration setting to make all runways available.
Post Reply