half default/half FT terminals?

Post Reply
newtie
Posts: 9

half default/half FT terminals?

Post by newtie » Thu Oct 01, 2020 5:01 pm

Hi

Fresh install of 1.2 in V5.

As you can see, somethings up with the terminals.

Any ideas on what causes this?

Thanks,
Mark

https://ibb.co/PC9vvfQ
https://ibb.co/hK6TPwr
newtie
Posts: 9

Re: half default/half FT terminals?

Post by newtie » Tue Oct 06, 2020 6:05 pm

Is this a support forum?
emilios[flytampa]
Site Admin
Posts: 1278

Re: half default/half FT terminals?

Post by emilios[flytampa] » Sat Oct 10, 2020 5:36 am

Is there any chance that, after the v1.2 installation, you have used an alternative AFCAD file?
Post Reply