[MSFS] glideslope too low?

Post Reply
sgwkelly
Posts: 6

[MSFS] glideslope too low?

Post by sgwkelly » Wed Dec 30, 2020 1:53 pm

Just purchased and installed KLAS for MSFS 2020 (v 1.2). Everything looks great, apart from the glideslope for 26L seems too low. Tested a couple of times - ok at initial capture (i.e., seems to be aligned with PAPI - 2 red / 2 white), but by around 3-4 miles out, the GS 'guides' you below the correct approach profile (giving you 4 red PAPI and, if you continue to follow the GS, putting you into the houses some way short of rwy 26L). Tried reinstall etc. - no change. Anyone else have this problem?
emilios[flytampa]
Site Admin
Posts: 1368

Re: [MSFS] glideslope too low?

Post by emilios[flytampa] » Sat Jan 02, 2021 3:20 pm

Strange- this issue had appeared in the immediately previous version of MSFS, and was fixed before release. Will test again and update
JEP795
Posts: 1

Re: [MSFS] glideslope too low?

Post by JEP795 » Mon Feb 22, 2021 4:55 pm

emilios[flytampa] wrote:
Sat Jan 02, 2021 3:20 pm
Strange- this issue had appeared in the immediately previous version of MSFS, and was fixed before release. Will test again and update
Hi Emilios,

I have the MSFS Marketplace Version and can confirm this happened to me yesterday as well so it seems to be an issue with the current version also.

Regards,
Jonathan
Post Reply