Hi,
Just bought the upgrade for FS9 to the FlyTampa Vienna product. The version 1 install had various vehicles driving about the airport - buses, tugs, etc.
Installed the upgrade over the top of the initial version and found that although the scenery is still stunning, the airport is dead quiet - no more moving vehicles!
Checked my settings and yes I have not changed anything and still have Dynamic Scenery enabled.
Checked my scenery.cfg and found two entries for the same scenery! I removed the entry for the original scenery, loaded FS9 and still the same problem.
I then un-installed the earlier version completely and then ran just the V2 installer as it seems that this is all that is needed. I reloaded FS9 and still no moving vehicles.
I checked the SCENERY folder of the original FlyTampa-Vienna installation from a backup and found that in the original version, there are two Vehicle_Anim.bgl files. There seems to be no such file(s) in the new V2 installation.
I note that several bits have been removed from the new version which was recompiled but there is no mention of moving ground vehicles - only that one should use AES for service traffic (which I don't use for reasons I cannot go into here).
Is this correct that there are no more moving vehicles? Did I do right in removing the old scenery and installing the V2 straight from new and NOT over the top of the old one?
Thanks for your kind help,
Regards,
Lee James


