Board index » FlyTampa » St. Maarten - TNCM - TFFJ - SABA

[MattB]

After I installed St. Maarten an "island" was created off of Saba. Did I do something wrong? I love the scenery and I have Tampa- rebooted and the Grenadines all of which is very good! Could someone please help get rid of my "island"

I have a Dell Studio xps 8100
Windows 7 64 bit
ATI Radion HD 5700
Intel Core i7 cpu 2.9 G
8gb Ram

My order #4740969

[martin[flytampa]]

Can you post a screenshot of this green item. I have no idea what it could be at this point.

[MattB]

Ok here ya go...

green "island"

green island.jpg (48.57 KiB) Viewed 918 times

[martin[flytampa]]

I doubt this is caused by our Addon. You probably have some additional Addons which need to be checked.
One way is to start removing potential entries from the Scenery Library until this "land" is gone, then check which one is causing it. Best to start with the FlyTampa-Maarten entry just in case.

[maartenzw]

Hello,
I have exact the same problem, also that stange "island" just before Saba.
When I move my aircraft to Saba airport within FSX I don't have a runway and also that island.
When I overflew Saba I do see the runway and all looks OK except the stange island.
I also works with Windows 7, 64 bit and FSX.
Could anybody help me to??

Maarten

[ebruto]

I had the same problem with the green island square near SABA. After many attempts I found that you must delete at the SCENERY directory the file "cvxSABA_SHAPES.BGL ". The Green Island then disappears. After this, didn't notice any effect on my scenario of SABA. It was the only solution I found..