Board index » FlyTampa » FlyTampa-Vienna

Post
 bosflyer (Fri Jan 11, 2019 5:02 pm)

Posts: 5
Somehow I just found out about this update recently after using Vienna for years. I quickly deleted my old Vienna from P3D V4 and ran the new installer. I discovered that the scenery did not install but the weird thing is that the sky terminal loads fine but nothing else. I then deleted it and read the manual. I ran the add on file but that didn't help. Then I checked to make sure the Vienna entries was in the main add on files and it was there but it was listed as entry number 1 and not at the end of the entries. What am I doing wrong?
Post
 martin[flytampa] (Sat Jan 12, 2019 4:35 pm)

Site Admin | Posts: 4841 | Location: Tampa/FL
It sounds like maybe the old version wasn't fully removed. Deactivate the new version and load LOWW to make sure its 100% back to default.
Post
 bosflyer (Sun Jan 13, 2019 4:05 pm)

Posts: 5
It seemed to work. I just deleted the entry from the scenery library and it just started working. Thank you