Hi,
I have enclosed a screenshot of the E-Concourse (particular E69) in Tampa, where none of the jet bridges are appearing. I am running P3Dv4.5. There is another thread where the solution was to check that there is no other AFCAD file for Tampa and "Check the setting again, the gates/jetways are tied to the Settings/World/Scenery Objects/Scenery Complexity Slider. That and another Afcad are the only 2 reasons I know of that can cause jetways to not show."
Help: How do I check if there is more than 1 (one) AFCAD installed and what is the Complexity slider?
https://www.flickr.com/photos/141330124 ... res/hBf16a
Thanks for help
Juergen Mader
Jet Bridges Not Showing
- martin[flytampa]
- Site Admin
- Posts: 5202
Re: Jet Bridges Not Showing
If the jetways are showing correctly at the other terminals but not E, the only reason I know of is the Scenery Complexity slider (note not Addon Complexity, but regular Scenery Complexity slider)
Re: Jet Bridges Not Showing
Martin,
The Scenery Complexity slider was set at "very dense". Set it to "dense", but still the jet bridges did not show up at terminal E.
Thanks for help
Juergen Mader
(could GSX be the culprit?)
The Scenery Complexity slider was set at "very dense". Set it to "dense", but still the jet bridges did not show up at terminal E.
Thanks for help
Juergen Mader
(could GSX be the culprit?)
- martin[flytampa]
- Site Admin
- Posts: 5202
Re: Jet Bridges Not Showing
Replace the attached file in /FlyTampa/Tampa/scenery/ overwriting the existing file there. This has all jetways set to very-sparse so they should appear.
- Attachments
-
- KTPA_ADEX_FLYTAMPA.bgl
- (129.28 KiB) Downloaded 78 times
Re: Jet Bridges Not Showing
Martin,
Checked it out and ALL jet-ways are there.
Appreciate your help very much
Thank you
Juergen Mader
Checked it out and ALL jet-ways are there.
Appreciate your help very much
Thank you
Juergen Mader
Re: Jet Bridges Not Showing
Martin will this work for P3D V5? I’ve got my scenery on extremely dense. I had no jetways at C or E gates. But had them at A/F gates.martin[flytampa] wrote: ↑Sun Apr 12, 2020 10:20 amReplace the attached file in /FlyTampa/Tampa/scenery/ overwriting the existing file there. This has all jetways set to very-sparse so they should appear.
Re: Jet Bridges Not Showing
Martin will this work for P3D V5? I’ve got my scenery on extremely dense. I had no jetways at C or E gates. But had them at A/F gates.martin[flytampa] wrote: ↑Sun Apr 12, 2020 10:20 amReplace the attached file in /FlyTampa/Tampa/scenery/ overwriting the existing file there. This has all jetways set to very-sparse so they should appear.