Missing jetwayes

Post Reply
Onmouse
Posts: 10

Missing jetwayes

Post by Onmouse » Thu May 30, 2019 1:15 am

I have no jetwayes, all the sliders to the right. Have updatet and deleted the 5 papi files.
2019-5-30_8-16-46-470.jpg
2019-5-30_8-16-46-470.jpg (534.83 KiB) Viewed 209 times
emilios[flytampa]
Site Admin
Posts: 888

Re: Missing jetwayes

Post by emilios[flytampa] » Thu May 30, 2019 5:43 am

If scenery slider is to maximum, then you are probably only seeing the static jets. Are you using any alternate AFCAD files, other than those installed with FT-Copenhagen?
Onmouse
Posts: 10

Re: Missing jetwayes

Post by Onmouse » Thu May 30, 2019 11:48 pm

only using EKCH files and the EKCH_P3Dv4_Patch.
emilios[flytampa]
Site Admin
Posts: 888

Re: Missing jetwayes

Post by emilios[flytampa] » Fri May 31, 2019 5:14 am

in 'P3D\FlyTampa\Copenhagen\scenery\' you should see

AF2_EKCH_FSX_ne
AF2_EKCH_FSX_sw
FT-jetwayLib.bgl

please .zip the first two (AF2_***) files and attach here to see if jetways are missing from your AFCAD files.
Onmouse
Posts: 10

Re: Missing jetwayes

Post by Onmouse » Sat Jun 01, 2019 1:48 am

here are the files
Attachments
flytampa-ekch.zip
(26.44 KiB) Downloaded 8 times
emilios[flytampa]
Site Admin
Posts: 888

Re: Missing jetwayes

Post by emilios[flytampa] » Sat Jun 01, 2019 6:25 am

If the attached files dont work, I would suggest a re-install. Also, do a check on your P3D installation folder in case there are other EKCH AFCAD files from other add-ons, ie Traffic add-ons, previous EKCH add-ons etc..

last, also make sure that the FTCopenhagen entries are on the top of your scenery library
Attachments
ft-EKCH_AF2.zip
(24.29 KiB) Downloaded 9 times
Post Reply